Why choose high-quality welding gun or welding fittings

But more often than not Maybe you are not as your thinking,the main factors hindering the development of welding torch making a demanding job less so is holding on to misconceptions about the way things are when it comes to welding working.
We all know this way,Welding gun is not fashionable,Can’t achieve both fashion and practicality,Even a small change for welding gun, It’s a huge project for welding torches,What we can do is to shorten the welding time and reduce the welding cost as much as possible.Only this can achieve productivity goals and cut costs.
We looked at some of comments from weld welder, and found the most common that are said all the time that could be holding you back.
“high imitation Contact Tips and Nozzle always Good and can Save more Money”
There are so many manufacturers too many imitation or euro type or other type of tips and nozzles,sometimes we even know,You’re using an mig gun from unknown manufacturer,high quality contact tips and nozzle are your best choice coule be save more working time,This is a problem you didn’t realize about save more working time and cost,There is a fundamental difference between high-quality conductive nozzles and nozzles and the manufacturing process of imitation products.
There are many problems that are easily overlooked information,For example, the wire feed aperture will appear uneven and barbs,even the size is inconsistent, and contact tips and nozzles won’t working so long time.They will also have differences in raw material grades,You’re also going use a poor quality copper and recycled copper,too.It’s easy to choose a high-quality contact tips and nozzle,the better quality the material grade the more durable and lasting the contact tip and nozzle will be welding so long. The only way to see a difference is do a side by side up close, make test one by one them.then you will know the result.You can’t think of the above data without testing.
It costs a lot to have your welder or welding robot stop down to change a tip because it not working so long and failed advanced; waste more the cost savings of an imitation contact tips and nozzle. The 10 minutes your robot cell may be down will cost far more to your operating cost,than the 20cents you may save going with an imitation contact tip over .Robot cell downtime can cost up to $10,000 per 10 minutes in high-efficiency operations.
You can preliminarily calculate the cost of a single occurrence of a problem. In the long run, it will be a huge expense.So choosing the right manufacturer and high-quality welding products is your right choice. Instead of just buying low-priced products.This is a question worthy of long-term discussion and consideration.